With the New
Year well underway it's time for more info about what we've been up to while hibernating
over Christmas.
We've
go big plans for 2013, starting with a line of accessories for table-top games
while expanding our replicas and reproductions. To start off we are looking at
3D asteroids for space combat games.
Plastics
are a relatively new medium for us, as we tend to work in metal and wood.
Still, they have a finish that is second to none, and in terms of gaming
accessories are perfect for table-top use. So we came up with the idea of
floating asteroids. Starting with the space rocks themselves, we carved them
from high density polystyrene.
 |
| Starting block of polystyrene. |
 |
| Adjustable band sawing the large block into square, asteroid friendly chunks |
 |
| Ready to be shaped |
 |
| Finally in asteroid shape |
Once we have an approximate shape we can finish them with the right colouring. The white layer adds strength to them, giving them a hard shell so that they can take knocks and wear and tear, then the black starts the finished look.
 |
| Undercoated and ready. |
 |
| Spraying black as a base for the final coat. |
Lastly we paint them dark grey and highlight them in lighter grey, and there you have it - asteroids all ready to go (more pictures and how we do the bases soon).
We also had an enquiry about swords for stage shows and props. The brief was 'as long as they look like roman swords, and are cheap', so we did some research.
 |
| Gladius (picture courtesy of http://www.legioxv.org/) |
We found the Roman Gladius, and the designer was pleased with this, so we then had to work out how to make two of these, very cheaply, which would still look good on stage (and also be safe to use!). We got right on it, as you can see.
We started looking at how we would attach the handles to the blades, and came up with welding split pins to them and drilling into the hafts.
 |
| Taken with the flash so that the burning rods can be seen. |
 |
| These are the joins from the blade to the rod which sits inside the haft |
 |
| By using the same material as the blades, we got the right joint size before welding. |
 |
| The cut blades ready for action, with ground edges and blunted tips |
 |
| We made sure we tested the edges and tips several times to make sure they we completely safe. In the above picture they were still too pointed, so it was out with the grinder again. |
 |
| Post-welding together, the blades and the haft-rods. |
 |
| Ready to be assembled with the undercoated hafts. |
 |
| Trying the hafts on for size. |
 |
| The final result, ready for the stage. Not as intricate as would be necessary for a wall or historical re-enactment, however perfect for a few chose moments on stage. |
The results are clearly visible gladius swords, with theatrical edges (rounded off and blunted), for a low cost and only taking two days to make. The designer was very happy, and we will be selling them off after the production.
To see the production of Cymbeline, go to the Drayton Theatre website to book tickets,
and for more info on commissioning us for props and replicas visit our facebook page or email us.
